CRC Rust Converter 250ml - Neutralises Rust

Directions:

1. Apply only when temperatures are between 10°C and 32°C.
2. Remove blistered, loose paint, other surface coatings and loose or heavy rust scale with a scraper or mechanical sander.
3. Remove dirt, grease, oil and other contaminants from surrounding surfaces and mask surrounding area.
4. Use of rubber gloves is recommended.
5. Mix or shake well before using.
6. Pour estimated amount needed into a clean container. Note: Material cannot be returned to original container after use.
7. For maximum penetration, work CRC Rust Converter into rusted surfaces with a synthetic bristle brush. For large areas, use a roller or sprayer.
8. Clean all painting equipment immediately after use with cold water.
9. Allow at least 12 hours cure time before overcoating.
10. If painting, for best long-term results, spray with CRC Metal Armour to provide a protective primer coat.
11. Overcoat with an enamel top coat for best results. If using a water based topcoat use a stain-blocking primer to avoid staining.
12. Protect CRC Rust Converter from freezing in the container. Store above 5˚C.

Disclaimer: CRC Rust Converter will not prevent further rusting when applied to heavy rust scale. It is not suitable as a rust preventative coating and should never be used to treat steel which is new or not rusting. It is not designed for use on non-ferrous metals, galvanised or stainless steel. Test on a small, inconspicuous area before use to ensure material compatibility.